Serious question, did you know the wiring on a 737 rudder position sensor runs through 3 separate connectors before it ever hits the box? | Avionics Technicians - Pinecone Attack
Serious question, did you know the wiring on a 737 rudder position sensor runs through 3 separate connectors before it ever hits the box?
I was tracing a bad signal on a rudder feel sensor last Tuesday up in Seattle and about halfway through the run I counted the connectors. Three of them between the sensor and the rack, and every one of them is a spot where corrosion can sneak in and give you a ghost reading. I always figured it was a straight shot like most of the other position pickoffs we deal with. The older guy in my shop shrugged and said that layout has been there since the 60s and nobody ever changed it because it works most of the time. It got me thinking about how many of my intermittent squawks are actually just a dirty pin inside connector number two instead of a bad sensor. We swapped the sensor first, of course, and the fault came right back on a test flight. Two hours of pin checks later the real culprit was a chafed wire right after the middle connector. How do you all decide when to break out the meter versus just throwing a part at it?